The OEM modules
are fully functional BASIC Stamps. It is programmed using our PBASIC DOS
or Windows Editor just like the BS2-IC module. Please note that the lower
power mode is only available when the regulator is removed and the BASIC
Stamp is powered on the vdd.
The documentation includes a complete bill of materials with three sources
and part numbers for each component. The BASIC Stamp Windows editor and
BASIC Stamp manual may be downloaded separately if you don’t already
have them. Measures 5.1 x 5.1 cm (2x2”). Shown here assembled and
tested.
Overview
The OEM BASIC Stamp 1 is a through-hole
version of the popular BASIC Stamp 1 module. The kit includes the
PBASIC interpreter, EEPROM, resonator, DB-9, and all the resistors
and transistors needed to build a BASIC Stamp 1. Presented in
a 14-pin SIP module format with standard 0.1” spacing.
The OEM BASIC Stamp 2 is a through-hole
version of the popular BASIC Stamp 2 module. The kit includes the
PBASIC interpreter, EEPROM, resonator, DB-9, and all the resistors
and transistors needed to build a BASIC Stamp 2. Presented in
a 20-pin SIP module format with standard 0.1” spacing. The PC
board includes labeled component locations with visible traces
between parts. PBASIC interpreter and EEPROM are socketed to allow
for replacement.
The OEM BASIC Stamp 2sx is a through-hole
version of the fast BASIC Stamp 2sx module. The PC board includes
labeled component locations with visible traces between parts.
PBASIC interpreter and EEPROM are socketed to allow for replacement.
