|
Stock#: 30053
Category: Audio Visual
320 x 240 Graphic Amulet Easy GUI 5.7
Starter Kit with Bezel
320 x 240 Graphic Amulet
Easy GUI 5.7 Starter Kit with Bezel
|
DESCRIPTION: The GUI Starter Kit
includes a 1/4 VGA, 5.7" diagonal monochrome display with a
CCFL backlight, a fully-integrated analog touch panel, and the
Amulet Controller Board. In addition, you will receive a serial
cable, development software CD, stylus touchpen, AC power adapter
and is mounted in a high quality bezel. Size is 201 x 124 mm (7.9 x
4.9 in.)
Important Note: To operate this kit with the standard GUI,
you must have a BS2-IC or higher and a BASIC Stamp Activity Board
(#27905). The Amulet device connects to your programming board with
a cable.
Creating a feature-rich graphical user interface is as easy as 1, 2,
3! Simply use HTML authoring software to create the user interface
layout; two, compile the user interface pages using the Amulet
compiler; and three, program the flash. Your Easy GUI is now ready
to navigate!"
Key Features of the Amulet Graphical User Interface Solution:
HTML-Based GUI Creation - create and edit quickly using
drag-and-drop HTML tool
Compiler Included - converts from HTML, JPEG, and GIF into
small, quickly-executable Amulet µHTML pages
Dedicated GUI Chip - manages the GUI, interacts with the
user, and controls the LCD--Frees up your BASIC Stamp
Combination Chip - The chip is a combination LCD controller
chip and user interface chip
Easy GUI Documentation Set Up and Startup Notes:
The Easy GUI controller board comes equipped with a 2.5 mm external
power connector (J3). The power requirement is 9 to 14 VDC @250 mA.
CAUTION: Do not reverse the polarity on the power input. Doing so
will permanently damage the module and invalidate your warranty.
Easy GUI comes pre-programmed from the factory with sample pages
stored in the onboard flash. To power up the Easy GUI Starter Kit
and begin GUI navigation, proceed as follows:
1. Make sure the DIP switch settings on SW2 are set to the following
values:
2. Connect the power adapter to the power input on
the PC Board; connect the other end of the adpter to the appropriate
power source.
3. The unit powers up and displays the Easy GUI Home Page. Use a
touch panel stylus to navigate the GUI (a stylus is included in the
Kit). Note: Use potentiometer VR1 on the board to adjust the LCD
contrast. For LED backlit displays, use VR2 to adjust the backlight
brightness.
GUI Interface for the Boe-Bot
In addition to the standard GUI interface that is geared toward the
BASIC Stamp Activity Board, Amulet has created a GUI for the Boe-Bot.
You can remotely control a Boe-Bot via RF using icons on the Amulet
display screen. In order to utilize the interface, you will need to
have a Boe-Bot, RF Transmitter/Receiver, and an additional BS2 and
Board of Education. Check out the Related Resources section below
for more information to take your Boe-Bot to the next level.
320 x 240 Graphic Amulet Easy GUI 5.7 Starter Kit with Bezel
|
